Home

OH&S

Roof Ready

Guarantees

Job Vacancies

Contact Us

Boral - Slimline

Click to enlarge

Innovative. Bold. Modern. The Slimline's unique design is right at home on Australia's most progressive structures. Its low profile and clean, angular lines result in a roof that is as eye-catching as the home it's a part of.

For more information, please visit this products webpage.

Gunmetal	Dark Chocolate	Terra Rossa	Ebony

Coverage	No. of tiles per m (squared): 9.2
Dimensions (Nominal)	Actual length: Actual width: Exposed length: Exposed width:	432 mm 336 mm 357 mm 308 mm
Mass (Nominal)	Mass per tile:	4.80 kg
	Mass per m (squared):	44.16 kg
Set Out (Nominal)	Batten spacing:	357 mm max.
Head Lap	Minimum head lap shall be 75 mm. This may increase according to set out. However, head lap should not exceed 120 mm.
Recommended Bond	Straight Bond / Cross Bond

Minimum Roof Pitch	Minimum recommended pitch under normal conditions, is 15° with sarking and 20° without sarking. Sarking may be required at pitches greater than 20° in areas requiring special consideration, such as coastal areas and exposed or elevated sites.
Maximum rafter length	At the minimum roof pitch the maximum rafter length allowed is 4.5 metres. For rafter lengths over 4.5 metres, Boral Roofing recommends you add 2° to the pitch for every metre of additional rafter length.
Quality	All tiles are designed to conform to the Australian Standards and good trade practice, AS 2049 Roof Tiles, and AS 2050 installation of Roof Tiles. All Boral roof tiles are tested by both Boral Roofing and the CSIRO Division of Building, Construction and Engineering to ensure the highest standards of quality, durability and performance.
Colours and Finishes	Please refer to the "BoralCreate" roofing brochures to determine the colours and finishes available in your state.
General	Product information contained in this leaflet is correct at time of printing. However, due to Boral's commitment for continued improvement, specifications are subject to change without notice. Boral Roofing's liability is limited to the replacement of product should it fail to perform as specified in literature current at the date of manufacture. Fixing standards and product specifications contained in this leaflet are minimum recommendations based on Australian Standards and good trade practice. However, we recommend that local authorities are consulted as they may require different standards to be met.
Note	The data shown in this specification sheet may vary from state to state. Whenever necessary please contact your Boral Roofing State Sales Office for more accurate details.